Auto-Clamping Air Vent Phone Mount

A flat charging face and spring-loaded arms form the head: the arms swing outward as a phone is pressed onto the pad, then close against the device edges. A slotted clip on the back hooks onto the slats of a car air vent, joined to the head by a ball joint that tilts the assembly up or down. Molded black ABS covers the coil housing, arms, and clip as a unified shell, with rounded inner lips facing the phone. A power cable ports in at the rear of the head to feed the charging face, and the mount sits at vent height with the screen angled toward the driver's seat.

• Auto-clamping arms push outward as a phone is set on the pad, then close against the case to hold the device in place
• A curved back clip hooks between the vent slats, so the mount anchors to the air duct without adhesive or a suction cup
• The arms carry broad flat inner faces that meet the phone across the case back rather than only at the rim
• A recessed circular pad at the head center seats the phone flat against the charging coil, holding the device upright on the vent
• A power cable exits the rear of the head, running behind the vent to the vehicle power socket below the dashboard