Earphone with Clip and Case

An open-ear earbud set pairs silicone-coated hooks that wrap around the auricle with a rounded charging case that stores both buds inside. Each bud houses a driver and microphone behind an acoustic chamber, secured by a snap joint where the hook meets the body. You open the case, drop each bud into its well, set the flat base on a desk corner, and run a short cable to top the pack between uses. On a trade counter or in a bilingual meeting, a user clips the buds on either side, speaks into one, and receives the translated voice through the other.

• The earhook curves over the outer ear, leaving the canal fully open so ambient noise and spoken words reach the eardrum directly
• In face-to-face mode each wearer clips an earbud, speaks, and hears a translated voice relayed from the paired unit worn opposite
• The charging case sits flat on a desk corner with a cable port along its rear edge, ready to accept the buds inside
• The silicone layer on the hook sits flush against the ear rim, spreading the contact across the curve rather than a single point
• A friction hinge props the lid open at the angle you set it, exposing the charging pins so you align each bud before releasing