High Quality QI Wireless Charger for Smart Phone wireless charging

The unit is a small ABS shell with a spring-loaded clip running through its back and a pair of curved cradle arms on the front. The clip is anchored by a hinge pin near the base so the shell can be slid onto a vent slat and pulled tight with one hand. You release it by squeezing the lower tab, which opens the jaws enough to lift the whole assembly off the blade. Inside the face, a coil plate sits behind a plastic cover, and a power cable threads out to the lighter socket. The cradle arms carry soft pads on the inner edge so the device rests without rubbing against the frame. A driver sets the phone into the arms at eye level and reads maps without reaching below the dash.

• Spring steel jaws clamp onto a slatted air vent blade and hold the unit steady without tools
• Curved pawls rise on both sides to cradle a phone upright and stop it shifting while driving
• A cable tail threads out through the clip base to the vehicle lighter socket or a hidden USB port
• Textured inner pads seat between the vent slats and keep the shell planted during stop-and-go traffic
• Flat ABS shell stays narrow enough to leave the vent dial and airflow controls open to the hand